This is how you change the code on your Gatehouse door lock.
- Enter your 6-digit programming code and hit the lock button.
- Enter “30” and hit the lock button.
- Enter 1-2-3-4-5-6 and then the lock button to delete this default user code.
- Wait ten seconds for the light to go off.
How do you program a LockState deadbolt?
Enter the following on the keypad: [Programming Code] + 140 + LockState Button 3. You will see 2 green flashes and hear two beeps if successful Note: For the lever lock, you do not need to perform this operation. Your lock has a built in Wi-Fi chip that allows you to program and control your lock from the internet.
How do you change the code on a Schlage keypad door lock without programming code?
So first how to Reset Schlage Keypad lock?
- Disconnect the batteries.
- Press and hold the Outside Schlage Button.
- While holding the Outside Schlage Button, Reconnect the batteries.
- Release the Outside Schlage Button.
- To check that the lock was reset, press the Outside Schlage Button and enter one of the Default User.
How do you change the code on a gatehouse lock?
This is how you change the code on your Gatehouse door lock. Enter your 6-digit programming code and hit the lock button. Enter “30” and hit the lock button. Enter 1-2-3-4-5-6 and then the lock button to delete this default user code.
What is the programming code for the gatehouse deadbolt?
Gatehouse Electronic Keypad Deadbolt comes with a preset programming code—123456. This code gives you access to all other settings. That is, you need to enter your programming code to add or delete user codes, reset the lock, etc. Note: Your programming code is also your master code, which is 123456 (preset).
How do you reprogram a defiant lock set?
Instructions for Defiant Lock Sets Install the proper latch plate cover supplied with the lock. Adjust the latch to the back-set dimension of the door. Tap the latch into the latch cutout in the door with the hammer and block. Install the latch with a screwdriver and two screws provided.
